Table of Contents
Advertisement
STORAGE
2. Screw the oil dipstick off and screw the drain bolt off the crankcase
to drain the oil out completely. And then tighten the drain bolt and fill
fresh oil to upper mark, finally reinstall the oil dipstick well.
3. Remove the spark plug, and pour about a tablespoon of clean engine
oil into the cylinder. Crank the engine several revolutions to distribute
the oil, then reinstall the spark plug.
4. Slowly pull the starter grip until resistance is felt. Let the intake and
exhaust valves in closing position.
5. Place the welder in the clean and dry area.
· 26 ·
Advertisement
Table of Contents
