Baumer Hubner Berlin PMG 10 Installation And Operating Instructions Manual page 14

Absolute encoder with magnetic sensing

Hide thumbs Also See for Hubner Berlin PMG 10:

Table of Contents

MOUNTING

4.3

Maximum permissible mounting tolerance when the Baumer Hübner K 35 spring

disk coupling is used

Encoders should be driven through the Baumer Hübner K 35 spring disk coupling (acces-

sory), that can be pushed onto the shaft without axial loading�

The figure below shows the version with EURO flange B10, the same maximum

permissible mounting tolerances are valid at version with housing foot B3�

)

The encoder must be mounted on the drive with the least possible angular error

and parallel misalignment�

)

Risk of damaging the ball bearings

Coupling components must not be driven onto the shaft with improper force (e� g�

hammer impacts), because of the risk of damaging the ball bearings�

Admissible

parallel misalignment

* For insulated hub version

All dimensions in millimeters, unless otherwise stated�

11/33

2-10

Admissible

angular error

MB245EN - 11171693, 17A2, Baumer_PMG10-SSI_II_EN

Admissible

axial movement

±0.7 (±0.3*)

Table of Contents