Step 6: Connecting The Drain Hoses - KitchenAid KDDS 6010 Assembly Instructions Manual

5019_102_00273_INSTAL_GB

Step 6: connecting the drain hoses

with Hose Joiner (see Plumbing Options).
R
Remember to slip the wire clip(s) on the drain hose(s) first.
15a Slip a wire clip over each drain hose, then push the hoses into
the Drain Hose Joiner firmly, 5 clicks. Position the wire clip(s)
between the two positioning ribs on the Drain Hose Joiner.
15b Attach the Drain Hose Joiner to the waste tee (see Plumbing
Options). Ensure a snug fit. If required a hose clamp may be
used.
16 When using the standpipe option (see Plumbing Options),
hose(s) should not extend further than 120mm down the
standpipe, in order to prevent siphoning.
Attach the Drain Hose Support to the cabinetry (with the screw
supplied) to prevent siphoning and to keep the drain hose(s)
from kinking. If required, the Drain Hose(s) may be trimmed to
a suitable length.
Important!
Minimum hole size to be connected to the drain system is
12.7mm.
The Drain Hose support must be used.
Ensure the Drain Hose(s) are fully extended to prevent
sagging (see diagram to left).
Drain Hose joiner must not support weight of hoses. Keep
excess length of Drain Hose on the
Hose support or trim to suit.
30-05-2007 13:25 Pagina 18
R side of the Drain
18
15a
WIRE
CLIP
WIRE
CLIP
SINGLE
DRAIN DRAIN HOSE
HOSE JOINER WASTE
DOUBLE
SUPPORT TEE
DRAIN HOSE
JOINER
VENT
WATER
16
SUPPLY
POWER
OUTLET
120mm
Maximum
38mm
STANDPIPE
(see Plumbing
Options 1 or 2)
WASTE
TEE
WATER
SUPPLY
15b