Table of Contents
Advertisement
5019_102_00273_INSTAL_GB
The cavity - single models
90°
97mm
+
67mm
These marks indicate mounting tab screw locations (refer to step 1 page 7)
NOTE: All depth measurements are taken from the front face of the adjacent cabinetry.
NOTE: To align drawer front to adjacent cabinetry, the product to counter top clearance can be increased
from 3mm.
Important!
Adjacent cabinetry must not extend above cavity base.
WARNING!
Ensure the edges of the services hole are smooth or covered to prevent damage to the power
cord or hoses.
30-05-2007
13:25
Moisture
Protection Tape
Ø50mm services hole
immediately
adjacent to corner,
+
+
can be either side
580mm
throughout cavity
600mm
Pagina 12
10mm
benchtop
10mm
Minimum
thickness of
cavity sides
+
is 16mm
12
moisture
protection
tape
Advertisement
Table of Contents
