Appendix B: Ignition Control Setup - Lanner R6S User Manual

R6S User Manual

Appendix B: Ignition Control Setup

Connecting the Devices
The system comes with a controller to ensure that the device is well-shielded against premature failure at the
boot or shutdown phase. When installing:
1. Make sure both your vehicle and the system are turned off.
2. Follow the wiring definition and illustration below to connect the vehicle battery and ignition (ACC)
to the in-vehicle system through the 5-pin M12 male connector marked as "DC Input" on the system,
through the right pin contact.
In a typical in-vehicle computing solution, this system usually acts as a PSE (Power Sourcing Equipment) to
power up connected PoE devices, for which you should ensure a minimum of 48V DC power supply to the
system with the use of a DC to DC Adapter.
Back
７ ６