Table of Contents
Advertisement
R6S User Manual
Notice
(1) A Unshielded-type power cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that only the supplied power cord by
used.
(2) Use only shielded cables to connect I/O devices to this equipment.
(3) Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
EMC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. The operation of this equipment in a
residential area is likely to cause harmful interference in which case users will be required to correct the
interference at their own expense.
Safety Guidelines
Follow these guidelines to ensure general safety:
•
Keep the chassis area clear and dust-free during and after installation.
•
Do not wear loose clothing or jewelry that could get caught in the chassis. Fasten your tie or scarf and
roll up your sleeves.
•
Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
•
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
•
Disconnect all power by turning off the power and unplugging the power cord before installing or
removing a chassis or working near power supplies
•
Do not work alone if potentially hazardous conditions exist.
•
Never assume that power is disconnected from a circuit; always check the circuit.
Consignes de sécurité
Suivez ces consignes pour assurer la sécurité générale :
•
Laissez la zone du châssis propre et sans poussière pendant et après l'installation.
•
Ne portez pas de vêtements amples ou de bijoux qui pourraient être pris dans le châssis. Attachez votre
cravate ou écharpe et remontez vos manches.
•
Portez des lunettes de sécurité pour protéger vos yeux.
•
N'effectuez aucune action qui pourrait créer un danger pour d'autres ou rendre l'équipement dangereux.
•
Coupez complètement l'alimentation en éteignant l'alimentation et en débranchant le cordon
d'alimentation avant d'installer ou de retirer un châssis ou de travailler à proximité de sources
d'alimentation.
•
Ne travaillez pas seul si des conditions dangereuses sont présentes.
•
Ne considérez jamais que l'alimentation est coupée d'un circuit, vérifiez toujours le circuit. Cet appareil
génère, utilise et émet une énergie radiofréquence et, s'il n'est pas installé et utilisé conformément aux
instructions des fournisseurs de composants sans fil, il risque de provoquer des interférences dans les
communications radio.
Lithium Battery Caution
•
There is risk of explosion if the battery is replaced by an incorrect type.
Back
２
Advertisement
Table of Contents
