Camera module PCB bending is the main cause of G sensor inaccuracy:
1.
Zeus G sensor is on the rear camera module, so please check if the rear
CAM is working (for checking FPC contact).
2.
Remove the FPC and insert again.
3.
Check CON1301 to make sure there are no defects (sunken pins,
cracks, SMT issues).
Assembly tips of RCAM module:
1. Pre-bend the FPC.
2. Slip in the module on the left side first.
3. Only slightly press in the right side of the module.
PCB bending of the G sensor area
G sensor test fail- ASSY
CAM assembly