Ness Security Products IS100 Quick Setup Manual page 4

IS100 Quick Set-Up Guide
The IS100 Quick Set-Up Guide outlines the steps necessary to establish initial communication and
perform system set-up after the Ness V1000 & V2000 System hardware is mounted and wired with
peripheral devices.
The IS100 System Set-Up section outlines the steps necessary for IS100 system set-up. For more
detailed information on IS100, please use this guide in conjunction with the IS100 User Manual.
IS100 Network Configuration
The IS100 Communication Configuration outlines the steps necessary to establish communication with
the Ness V1000 & V2000 System controller.
!
If you are not familiar with the network configuration of your facility, please contact
the Network Administrator or IT Manager to perform the steps outlined below.
Once all hardware is mounted and wired, initial system set-up and configuration should be performed
•
with a client computer or laptop that is on the same network as the controller via a network switch OR
while connected directly to the controller with a computer/laptop and an Ethernet cable.
All Ness V1000, V2000 and 'Edge" System controllers are pre-programmed from the factory for
•
DHCP, where an IP Address is allocated by the system router.
In cases where a Router is not used, (e.g. Direct connect to a PC) then you can use the factory default
static IP Address which is
To establish communications between the computer/laptop and the Ness V1000, V2000 or 'Edge' System
controller, Ensure your PC network is configured to the same range as the default Static IP above, (e.g.
169.254.242.100) then enter the above IP address into your Web Browser Address field and then press
enter.
1.
From the Internet Explorer browser, navigate to the controller's IP address
07/07|V1.0 890-377
169.254.242.121
2007-2010© Ness Security Products. All rights reserved.
IS100 Quick Set-Up Guide
4