Table of Contents
Advertisement
Testing the STL-80BLD-INT System
Once the system is enabled to dispense flavors,
test each flavor to ensure they all dispense
properly and that the Blending Assembly
operates correctly. Draw several servings
choosing all the different options available for
your setup to verify the Color Touch Panel
settings are acceptable.
NOTE: EQUIPMENT AND PRODUCT
IMAGES MAY DIFFER FROM YOUR SETUP.
HOWEVER, THE INFORMATION AND
INSTRUCTIONS STILL APPLY.
1. Make your serving selections on the screen.
NOTE: DEPENDING ON YOUR SETUP, YOU
MAY FIRST BE ASKED TO MAKE
ADDITIONAL SELECTIONS FOR SERVING
CONTAINER TYPE AND SERVING SIZE
BEFORE MAKING FLAVOR SELECTIONS.
2. MANUAL DRAW: Hold a container under
the spout to catch flavor product. Pull the
draw handle down to dispense product. If
you have the timed servings enabled, draw
the serving until the system sounds a beep
and the screen notifies you to stop drawing
product. Return the handle to the closed
position at the end of the serving.
NOTE: IF YOUR SYSTEM HAS A DRAW
HANDLE SWITCH, PRESS THE SWITCH
AGAINST THE DRAW HANDLE WHILE
MOVING THE DRAW HANDLE INTO THE
FULL "OPEN" POSITION. THIS ACTIVATES
THE FLOW OF SYRUP TO THE SPOUT.
NOTE: IF THE FREEZER IS EQUIPPED
WITH A DRAW HANDLE SWITCH, RELEASE
THE SWITCH ONE SECOND BEFORE
CLOSING THE SERVING. THIS WILL STOP
THE FLOW OF SYRUP WHILE GIVING THE
UNFLAVORED PRODUCT ENOUGH TIME TO
CLEAR THE BLENDING HEAD OF EXTRA
FLAVORING AND REDUCE CARRYOVER.
NOTE: THE SYSTEM DISPENSES THE
FLAVORS IN THE ORDER THEY WERE
SELECTED. ALLOW ENOUGH TIME FOR
EACH OF THE FLAVORS TO CYCLE
THROUGH. IF THE SERVING IS CUT OFF
TOO SOON THE SYSTEM MAY NOT
DISPENSE ALL THE CHOSEN FLAVORS IN
YOUR SERVING.
65
Advertisement
Table of Contents
