Assembling The Blending Assembly - Stoelting Flavor Burst Operator's Manual

6. The following do not need to be sanitized on
a daily basis as part of the daily opening
procedures. However, inspect these areas
and if necessary, clean according to
instructions in the SCHEDULED
MAINTENANCE section:

9-Tube Assembly Coupler

9-Tube Assembly Tubes

Touch Panel and Mounting Bracket

Drive Motor

Exposed surfaces of Cabinet and Cart

Blending Assembly Suspension Bracket

Assembling the Blending Assembly

The Blending Head o-rings, the Gear Cartridge,
and the spout adapter o-rings are wear items
and will need to be replaced periodically.
Check for wear occasionally and always keep
spares of these items on hand in the Spare
Parts Kit.
1. Place the Gear Cartridge into the Gear Box
so that the gear teeth line up with the gear
inside the Gear Box.
2. Install the Blending Head onto the Gear Box
and rotate off-center to secure.
3. Insert the Drive Motor into the Gear Box so
that all four locking screws are seated
properly and rotate the motor clockwise to
secure.
4. Install the o-rings in their proper positions
on the adapter body.
23