Table of Contents
Advertisement
11. Align the coupler pins of the Lead with the
coupler pins of the 9-Tube Assembly and
connect the assemblies.
12. Slide the coupler casing over the connection
and screw each coupler nut into each end of
the casing. Tighten the coupler nuts to
secure the connection.
13. Place the connection on the floor of the cart,
under the cart shelf and away from the
electronics.
DO NOT PLACE THE 9-TUBE
ASSEMBLY AND LEAD CONNECTION
ABOVE OR NEAR THE PUMP ELECTRONIC
CONNECTIONS OR THE ELECTRONICS
BOARD. IF THE CONNECTION BECOMES
LOOSE OR IF THE SEAL BECOMES WORN
OVER TIME, LEAKAGE COULD OCCUR AND
COME IN CONTACT WITH THE PUMP CABLE
CONNECTIONS. THIS MAY RESULT IN
ELECTRICAL SHOCK AND DAMAGE TO THE
UNIT.
14. Ensure any excess tubing and cables are
tucked inside the cabinet and neatly out of
the way.
15. Install the cart panel to the back of the cart
and secure using the two screws provided.
Power Connections and Power Up
The electrical connections for the STL-80BLD-
INT are located on back of the Stoelting cart.
Once the cables have been attached and the
unit is turned on, the STL-80BLD-INT can
remain on during normal operations from day to
day. It does not need to be turned off unless it
is being serviced or moved, or unless it is not
used for a long period of time.
NOTE: ELELCTRICAL HAZARD - DO NOT
HANDLE OR OPERATE NEAR WATER.
1. Ensure the power-switch is in the "off"
position with the "
60
○
" end pressed in.
Advertisement
Table of Contents
