Led Display Signal; Components Of The Device; List - Samsung ARM BPM User Manual

INTRODUCTION
CAUTION
* Keep the unit out of reach of infants, young children or pets to avoid inhalation or
swallowing of small parts. It is dangerous or even fatal.
* Be careful to strangulation due to cables and hoses, particularly due to excessive length.
* At least 30 min required for ME equipment to warm from the minimum storage temperature
between uses until it is ready for intended use. At least 30 min required for ME equipment to
cool from the maximum storage temperature between uses until it is ready for intended use.
* This equipment needs to be installed and put into service in accordance with the
information provided in the ACCOMPANYING DOCUMENTS;
* Wireless communications equipment such as wireless home network devices, mobile
phones, cordless telephones and their base stations, walkie-talkies can affect this
equipment and should be kept at least a distance d away from the equipment. The distance
d is calculated by the MANUFACTURER from the 80MHz to 5.8 GHz column of Table 4 and
Table 9 of IEC 60601-1-2:2014, as appropriate.
* Please use ACCESSORIES and detachable parts specified/ authorised by
MANUFACTURE. Otherwise, it may cause damage to the unit or danger to the
user/patients.
* There is no luer lock connectors are used in the construction of tubing, there is a possibility
that they might be inadvertently connected to intravascular fluid systems, allowing air to be
pumped into a blood vessel.
* Please use the device under the environment which is provided in the user manual.
Otherwise, the performance and lifetime of the device will be impacted and reduced.

LED Display Signal

SYS
SYMBOL DESCRIPTION
Systolic blood pressure
Diastolic blood pressure
HR
Pulse
6
DIA HR
EXPLANATION
High pressure result
Low pressure result
Pulse/minute

Components of the Device

START/STOP BUTTON

List

2. Cuff (22~42cm)
1. SAMSUNG ARM BPM
(EI-B5000)
3. User manual 4. 4*AAA batteries
The Choice of Power Supply
1. Battery powered mode:
6VDC 4*AAA batteries
CAUTION
In order to get the best effect and protect your monitor,please use the
the right batteries and special power adapter which complies with local
safety standard.
Installing and Replacing the Batteries
If this is your first time using the device:
1. Slide open the battery door on the back of the device.
2. Install the batteries provided with the device. Follow
the diagram inside the battery compartment for correct
polarity—the springs should align with the negative
sign on the batteries.
3. Slide the battery door closed.
INTRODUCTION
Component list of
pressure measuring system:
1 Cuff
2 Air pipe
3 PCBA
4 Pump
5 Valve
BATTERY DOOR
BATTERY COMPARTMENT
(Type BF applied part)
7