Troubleshooting; Specifications - Samsung ARM BPM User Manual

TROUBLESHOOTING

This section includes a list of error messages and frequently
asked questions for problems you may encounter with your
SAMSUNG ARM BPM. If the products not operating as you think it
should, check here before arranging for servicing.
PROBLEM SYMPTOM
Display
Batteries are exhausted. Replace with new batteries
No power
will not light up
or Low
or
Batteries are inserted
batteries
incorrectly.
shows
The cuff is not secure
E 01 shows
or Inflatable abnormal.
The monitor detected
E 02 shows
motion, talking or the
pluse is too poor
while measuring.
The measurement
process does not detect
E 03 shows
the pulse signal.
Error
message
The treatment of the
E 04 shows
measurement failed.
EEx,shows on A calibration error
the display. occurred.
Warning
Out of measurement
"out" shows
range
message
18
CHECK THIS REMEDY
Insert the batteries
correctly
Refasten the cuff and then
measure again.
Movement can affect the
measurement. Relax for a
moment and then
measure again.
Loosen the clothing on the
arm and then measure
again
Relax for a moment and
then measure again.
Retake the measurement.
If the problem persists,
contact the retailer or our
customer service
department for further
assistance.Refer to the
warranty for contact
information and return
instructions.
Relax for a moment.
Refasten the cuff and then
measure again. If the
problem persists, contact
your physician.
Power supply
Battery powered mode: 6VDC 4×AAA batteries
Measurement mode
Oscillographic testing mode
Rated cuff pressure:
0mmHg~299mmHg (0kPa ~ 39.9kPa)
Measurement pressure:
Measurement range SYS: 60mmHg~230mmHg (8.0kPa~30.7kPa)
DIA: 40mmHg~130mmHg (5.3kPa~17.3kPa)
Pulse value: (40-199)beat/minute
Pressure:
5°C-40°C within ± 3mmHg (0.4kPa)
Accuracy
Pulse value: ±5%
A temperature range of: +5°C to +40°C
A relative humidity range of 15% to 90%,
non-condensing, but not requiring a water vapour
Normal working condition
partial pressure greater than 50 hPa
An atmospheric pressure range of:
700 hPa to 1060 hPa
Temperature: -20°C to +60°C
Storage & transportation
A relative humidity range of ≤ 93%, non-condensing,
condition
at a water vapour pressure up to 50hPa
Measurement perimeter
About 22cm~42cm
of the upper arm
Approx.285g(Excluding the batteries)
Weight
External dimensions
Approx.159mm*50mm*27mm
Attachment
4×AAA batteries,user manual
Continuous operation
Mode of operation
Degree of protection
Type BF applied part
Protection against
IP22: The first number 2: Protected against solid
foreign objects of 12,5mm Ф and greater. The
ingress of water
second number: Protected against vertically falling
water drops when enclosure titled up to 15º.
Vertically falling drops shall have no harmful effects
when the enclosure is titled at any angle up to 15º on
either side of the vertical
Battery Powered Mode:
Device Classification
Internally Powered ME Equipment
Software Version
A01
WARNING: No modification of this equipment is allowed.

SPECIFICATIONS

19