General Screen; Advanced Screen - ZyXEL Communications LTE3301-M209 User Manual

The sum of the bandwidth allotments that apply to the LAN interface (WAN to LAN, WAN to WLAN) must
be less than or equal to the downstream bandwidth that you configure in the Bandwidth Management
> General screen

19.4 General Screen

Use this screen to have the Zyxel Device apply bandwidth management.
Click Management > Bandwidth MGMT to open the bandwidth management General screen.
Figure 82 Management > Bandwidth Management > General
The following table describes the labels in this screen.
Table 57 Management > Bandwidth Management > General
LABEL
Enable Bandwidth
Management
Bandwidth of
Upstream
Bandwidth of
Downstream
Flexible Bandwidth
Management
Apply
Cancel

19.5 Advanced Screen

Use this screen to configure bandwidth management rules for the pre-defined services or applications.
Chapter 19 Bandwidth Management
Section 19.5 on page 120.
DESCRIPTION
This field allows you to have Zyxel Device apply bandwidth management.
Enable bandwidth management to give traffic that matches a bandwidth rule priority over
traffic that does not match a bandwidth rule.
Enabling bandwidth management also allows you to control the maximum or minimum
amounts of bandwidth that can be used by traffic that matches a bandwidth rule.
Specify the total amount of bandwidth that you want to dedicate to uplink traffic. The
recommendation is to set this to match the actual upstream data rate.
This is traffic from LAN/WLAN to WAN.
Specify the total amount of bandwidth that you want to dedicate to downlink traffic. The
recommendation is to set this to match the actual downstream data rate.
This is traffic from WAN to LAN/WLAN.
Select Enable to use up to 100% of the configured bandwidth. If you select Disable, you can
only use up to 33% of the configured bandwidth.
Click Apply to save your customized settings.
Click Cancel to begin configuring this screen afresh.
LTE3301-M209 User's Guide
120