Led Indication - ABB Eden DYN Product Manual

7 LED indication

The non-safe status LED on Adam shows the status of the Eden sensor and the output status as
follows:
LED on Adam
Green
Flashing green
Flashing red/green
Red
Fast flashing green
Fast flashing red
Flashing red
When Adam DYN-Status operates in StatusBus mode, the following LED statuses are also possible:
LED on Adam StatusBus
Double flash, red
0.11/0.2/0.11/0.67 s,
on/off/on/off
Double flash, green
0.11/0.2/0.11/0.67 s,
on/off/on/off
Off for 5 s, then flickering flash
0.07/1.9 s, on/off
Burst with stress flash. Burst
cycle: 0.8/0.4 s, on/off
2TLC172271M0201 Rev D
Description
Valid Eva within range
Valid Eva within range, waiting for reset
Valid Eva within range, no valid in signal
Valid Eva out of range
Valid Eva is within 2 mm from maximum detection
distance
Fail safe mode
No Eva programmed
Description
Sensor in StatusBus mode, off.
"Ready slave" Address 0.
Sensor in StatusBus mode, on.
Address 0.
Sensor in StatusBus mode, on.
Teach mode.
At the command from Pluto
Manager.
Safety circuit
Closed
Open
Open
Open
Closed
Open
Open
Eva is not within detection
distance during
addressing.
Addressed from 1–30 to 0.
Eva within detection
distance.
The flashing usually lasts for
1-4
seconds during the
addressing
(teach) process.
Visible sensor
identification.
24