WilTec 50144 Operation Manual page 8

Step 4-1
Nr. Description
1 Hopper
23 Slot
Turn the hopper (1) upside down and push the slot (23) completely into the guide channel on the un-
derside of the hopper.
Step 5
Nr. Description
1 Hopper
21 Screw M6x40
16 Small flat washer
18 Hex nut M6
3 Spinner disc
20 Release pin
19 Screw M6x55
17 Lock washer
Fasten the hopper (1) to the supports (5,6,7)
with the M6x40 screw (21), small washer (16) and hexagon nut (18). Fasten the hopper to the sprea-
ding disc (3) with the release pin (20).
Fasten the control cable (1-1) to the front bracket (9) with an M6x55 screw (19), a small flat washer
(16), a lock washer (17) and a cable lock nut (22).
Note! The control cable (1-1) comes pre-installed on the hopper.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Qty
1
1
Qty
1
4
5
5
1
1
1
2
Artikel 50144 Seite 8
11 2020-1