Simons Voss Technologies 3068 Manual page 29

6. Carefully refasten the battery holder on the circuit board (Fig. 3).
7. Put the casing back into position.
8. Fasten the two casing screws into the casing base again
9. Carry out the following steps to reset the battery alarm status:
a) Enter „0"
b) Enter „99"
c) Enter „99999"
All functions are ready to be used again once the battery replacement is complete.
Always replace both batteries as they basically discharge at the same rate.
While replacing the battery, ensure that no water can get inside the casing and the
electronics do not come into contact with the electronics. If needed, carefully dry the
section of the casing fastened to the wall.
Only ever use batteries approved by SimonsVoss.
11.0 MANIPULATION WARNING
A manipulation warning is integrated into the pin code terminal to prevent user PINs
being tried out on a systematic basis. When five unsuccessful attempts have been
made to enter a PIN (user PIN, master PIN and similar), a warning signal will sound for
60 seconds while the LED flashes red. The terminal cannot be operated during this
time.
If another incorrect PIN is entered, the terminal will immediately change to manipula-
tion mode. The counter will only reset to 0 when a correct PIN is entered.
29