Description; Safety - Textron HDE TAG-5000 Operating Instructions Manual

DESCRIPTION

The TAG-5000 Wireless Phaser
is a two unit system used to
verify an in-phase condition
between any two phases of a
three phase power system. The
TAG-5000 can be used anywhere
a typical phasing voltmeter is
used and many places where
phasing voltmeters cannot be
used due to distance or higher
voltages. The standard TAG-5000
is supplied with a carrying case,
the receiver and transmitter
units and two probes (one hook
and one"Y"probe) designed
for overhead use. The probes
are interchangeable between
the two units, and can be selected
based on preferred placement
and company procedures. Each
unit has a universal spline hotstick
attachment built into the housing.
Extension hotsticks should always be used. Both units are powered by 9V lithium or
alkaline batteries. Optional underground probes are available for underground or
pad mount applications or for any application where the TAG-5000 will be used i
close proximity to grounded conductors or surfaces.

SAFETY

• Only trained, professional operating personnel should use the TAG-5000. The voltages
this instrument operates at are dangerous and lethal. Severe injury or death can occur
if improperly used.
• Risk of electrocution is inherent in or around high voltage.
• Always use proper high voltage procedures, including personal protective equipment,
when working near or around high voltage equipment or conductors.
• Do not use on voltages less than the minimum voltage on the device label and do not
exceed the TAG-5000 maximum voltage rating of 230kV line-to-line.
• Always assemble the TAG-5000 with the proper contact probe for your application.
WIRELESS PH SING SET
CONVENTION L PH SING EQUIPMENT
3