Indoor building entrance terminal (ibet) 4790v and 4790vl series with 3m™ quick connect system (qcs) 2811 dry flame-retardant block and rj-11 test ports (10 pages)
Fiber dome terminal closure with external hfoc adapters (16 pages)
Summary of Contents for 3M 4588IPT Series
Page 1
Integrated Protection Terminals ™ 4588IPT and 4588IPTN Indoor Building Entrance Terminal with the fire retardant Quick Connect System (QCS) 2814 ™ Instructions Underwriters Laboratories (UL 348X) Listed October 2016 78-0015-0406-3-C...
Page 2
4588IPTN provide electrical protection and a termination point for outside plant cable and indoor house wiring. The 3M terminals 4588IPT and 4588IPTN series are Underwriters Laboratories (348X) Listed. Note: For Underwriters Laboratories Compliance, the 3M Integrated Protection Terminal 4588IPT - 100 pair ™...
Page 3
Note: Visually inspect all components. If any component is missing or appears damaged, do not install and Remove terminal from wall and place in a call 3M customer service at 1-800-426-8688 for a safe location. replacement product. Drive one mounting screw into location marked in 2.6.
Page 4
Route cable to splice chamber making sure gasket lines up and seals to bottom. 3.12 Use 3M Cable Ties, or equivalent cable ties, to secure the entrance cable to the back wall. 3.13 Route cable binders to appropriate block tails and splice per your company practice.
Page 5
5.1 Connect System (QCS) 2814 Block and 5.2. NOTE: 3M QCS 2810 block shown. Placing and routing jumpers is the same with 3M QCS 2814 blocks. Open the feeder pair jumper cap by pushing up on the latch and rotating up.
Page 6
October 2016 78-0015-0406-3-C 6.0 3M Quick Connect System (QCS) 2814 Ordering Information ™ Product Number Product Description 3M ID Minimum Order Blocks and Frames 2814AD QCS-A block (dry) with no ground bar XS-0038-4141-7 2811F100-30P QCS Frame, 30 mm pitch, 100-pair...
Page 7
78-0015-0406-3-C October 2016 7.0 Installing 3M Integrated ™ Protection Terminal 4588IPT 50 pair Wire Harness Kit g. Reinstall grommet allowing sufficient block length. h. Grasp the 1 – 10 block and align with the top frame tab. a. Loosen bolt and remove cover door and set aside.
Page 8
Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.