Advertisement
Q: How to connect Traveler 3G to 3G network?
A:
Please refer the following to configure Traveler 3G:
1. The Traveler 3G can be managed remotely by a PC through either the wired or
wireless network.
It is recommended to configure the router through the Ethernet port for the first
time setup.
The default IP address of the Traveler 3G is 192.168.1.1 with a subnet mask of
255.255.255.0.
This means the IP address of the PC should be in the range of 192.168.1.2 to
192.168.1.254.
2. Please power on Traveler 3G and connect PC to Traveler 3G by cable. (Please
switch the Ethernet port to LAN)
3. Please open your browser and type in the Traveler 3G's IP address(default IP is
192.168.1.1) into the web browser's address field.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AirLive Travaler 3G
Summary of Contents for AirLive Travaler 3G
- Page 1 Q: How to connect Traveler 3G to 3G network? Please refer the following to configure Traveler 3G: 1. The Traveler 3G can be managed remotely by a PC through either the wired or wireless network. It is recommended to configure the router through the Ethernet port for the first time setup.
- Page 2 4. Please input the user name and password. The default user name is “admin” and default password is “airlive”. 5.Please get into the 3G/3.5G setting page.
- Page 3 6. Please configure the 3G/3.5G setting. PIN code: Please enter the Pin Code for your SIM card. APN: Please enter the APN for your PC card.(Default is “internet”) Dial-Number: This field should not be altered except when required by your service provider.
Need help?
Do you have a question about the Travaler 3G and is the answer not in the manual?
Questions and answers