Table of Contents
Advertisement
Step 4. Install the MobileConnect Station
There are two versions of MobileConnect Station (MCS) hardware:
MCS v1
MCS v2
In order to use a MCS v1, you need to upgrade its firmware. For details, see section
Upgrading a legacy MobileConnect
•
Connect your MCS to the network
Use LAN2 (MCS v1) or PoE/Stream (MCS v2) port to connect your streaming network.
o
Use LAN3 (MCS v1) or Ctrl (MCS v2) port optionally to connect a second network for
o
configuration. If you don't wish to use a separate network, and the port is not connected, the
system will use the streaming network for control as well.
Note:
The network ports use DHCP by default. To configure a static IP:
o
Configure your PC with the static IP address 192.168.0.2, netmask: 255.255.255.0
§
Connect the LAN1 or Ctrl port directly to your PC
§
Open your browser and navigate to 192.168.0.10 to open the local admin interface
§
You can configure the network and a static IP address using the local admin interface
§
Version 1.0
Station.
MobileConnect User Guide
8
Advertisement
Table of Contents
