Installing/Removing The Pentium Ii - Siemens D981 Technical Manual

Installing/removing the Pentium II

Installing/removing the Pentium II
This system board you may use only with processors with a host bus
!
frequency of 66 MHz. Do not use processors with a host bus frequency of
100 MHz!
Installing the Pentium II
²
Place the Pentium II in the holder (1).
²
Push the Pentium II down in the holder and press it into the slot until the
clamps (2) to the left and right snap into place.
²
Set the clock frequency of the new Pentium II using switches 5 to 8 of the
switch block.
²
If the Pentium II has a fan, attach the associated cable to the connector for
the processor fan on the system board.
Removing the Pentium II
²
If the Pentium II has a fan, pull out the associated cable.
²
Press the clamps (2) on either side of the Pentium II inwards and pull the
Pentium II up and out.
A26361-D981-Z120-9-7419
Add-on modules
English - 11