Husqvarna ST 124 Operator's Manual page 9

containers on the ground, away from your
vehicle, before filling.
• When practical, remove gas-powered equipment
from the truck or trailer and refuel it on the
ground. If this is not possible, then refuel such
equipment on a trailer with a portable container,
rather than from a gasoline dispenser nozzle.
• Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times, until
refueling is complete. Do not use a nozzle lock-
open device.
• Replace gasoline cap securely and wipe up
spilled fuel.
• If fuel is spilled on clothing, change clothing
immediately.
• Use extension cords and receptacles as specified by
the manufacturer for all units with electric starting
motors.
• Adjust the collector housing height to clear gravel or
crushed rock surface.
• Never attempt to make any adjustments while the
engine (motor) is running (except when specifically
recommended by manufacturer).
Operation
• Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
• Exercise extreme caution when operating on or
crossing gravel drives or walks. Stay alert for hidden
hazards or operating near public roads.
• After striking a foreign object, stop the engine
(motor), remove the wire from the spark plug,
disconnect the cord on electric motors, thoroughly
inspect the snow thrower for any damage, and repair
the damage before restarting and operating the
snow thrower.
• If the machine should start to vibrate abnormally,
stop the engine (motor) and check immediately for
the cause. Vibration is generally a warning of
trouble.
• Stop the engine (motor) whenever you leave the
operating position, before unclogging the collector/
impeller housing or discharge chute, and when
making any repairs, adjustments or inspections.
• Do not run the engine indoors, except when starting
the engine and for transporting the snow thrower in
or out of the building. Open the outside doors;
exhaust fumes are dangerous.
• Exercise extreme caution when operating on slopes.
• Never operate the machine without proper guards
and other safety protective devices in place and
working.
• Never direct the discharge toward people or areas
where property damage can occur. Keep children
and others away.
• Do not overload the machine capacity by attempting
to clear snow at too fast a rate.
1272 - 005 - 16.06.2020
• Never operate the machine at high transport speeds
on slippery surfaces. Look behind and use care
when operating in reverse.
• Disengage power to the collector/impeller when the
machine is transported or not in use.
• Use only attachments and accessories approved by
the manufacturer of the machine (such as wheel
weights, counterweights or cabs).
• Never operate the machine without good visibility or
light. Always be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
• Never touch a hot engine or muffler.
Clearing a clogged discharge chute
• Hand contact with the rotating impeller inside the
discharge chute is the most common cause of injury
associated with snow throwers. Never use your hand
to clean out the discharge chute.
• To clear the chute:
1. SHUT THE ENGINE OFF!
2. Wait 10 s to be sure the impeller blades have
stopped rotating.
3. Always use a clean-out tool, not your hands.
Maintenance and storage
• Check shear bolts and other bolts at frequent
intervals for proper tightness to be sure the
equipment is in safe working condition.
• Never store the machine with fuel in the fuel tank
inside a building where ignition sources are present
such as hot water heaters, space heaters or clothes
dryers. Allow the engine to cool before storing in any
enclosure.
• Always refer to instruction handbook for important
details if the snow thrower is to be stored for an
extended period.
• Maintain or replace safety labels, as necessary.
• Run the machine a few minutes after throwing snow
to prevent freeze up of the collector/impeller.
• When cleaning, repairing or inspecting the snow
thrower, stop the engine and make certain the
collector/impeller and all moving parts have stopped.
Disconnect the spark plug wire and keep the wire
away from the plug to prevent someone from
accidentally starting the engine.
General safety instructions
• Use the product correctly. Injury or death is a
possible result of incorrect use. Only use the product
for the tasks found in this manual. Do not use the
product for other tasks.
• Obey the instructions in this manual. Obey the safety
symbols and the safety instructions. If the operator
does not obey the instructions and the symbols,
injury, damage or death is a possible result.
• Do not discard this manual. Use the instructions to
assemble, to operate and to keep your product in
good condition. Use the instructions for correct
9