Husqvarna ST 124 Operator's Manual page 7

Introduction..................................................................... 7
Safety..............................................................................8
Assembly...................................................................... 12
Operation...................................................................... 13
Maintenance................................................................. 15
Product overview
(Fig. 1)
1. Auger engagement
2. Drive speed control lever
3. Control panel
4. Auger cable
5. Chute rotator control
6. Chute deflector
7. Clean-out tool
8. Auger housing
9. Augers
10. Skid plate
11. Tire
12. Oil fill
13. Engine
14. Lower handle
15. Drive speed control rod
16. Drive cable
17. Recoil start handle
18. Drive engagement
19. Handle grips
20. Primer
21. Choke
22. Fuel switch
23. On/off key
24. Operator´s manual
Product description
The product is a snow thrower that is used to remove
snow from the ground.
Intended use
This product can be used to remove snow from fields,
roads, walkways and driveways. Do not use it on slopes
that are greater than 15°. Do not use the product in
areas where there is much debris, dirt and protruding
stones.
1272 - 005 - 16.06.2020
Contents
Troubleshooting............................................................ 17
Transportation, storage and disposal........................... 19
Technical data.............................................................. 19
EC Declaration of Conformity....................................... 21
Introduction
Symbols on the product
Note: If the decals on the product are damaged, contact
the distributor to replace them.
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
(Fig. 9)
(Fig. 10)
(Fig. 11)
(Fig. 12)
(Fig. 11)
(Fig. 13)
(Fig. 14)
(Fig. 15)
(Fig. 16)
(Fig. 17)
(Fig. 18)
(Fig. 19)
Warning.
Read the operator's manual.
Hot surface.
Risk of fire.
Choke.
Pull starter rope handle.
Do not breathe in the exhaust fumes from
the engine.
Do not put any part of the body into the
chute deflector or the auger housing when
the augers rotate.
Stop the engine before you remove snow
from the chute deflector. Use the clean-out
tool to remove snow, do not do it by hand.
Keep hands away from the chute deflector.
Objects can be ejected from the product.
Keep bystanders away from the product
when operating.
Remove key before maintenance.
Push in the on/off key to the RUN position.
Turn the fuel switch to the ON position.
Push the primer.
Risk of falling.
7