Settings And Displays - Siemens TK 52 Series Operating Instructions Manual

4 Coffee dispensing button
(strong coffee)
This button is used to dispense strong
coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
5 Steam generation button
The steam button generates steam for
h
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to or
g
steam, the steam generation button
must be pressed first (see "Steam for
foaming milk").
7 LED display
The various LEDs indicate the following:
on The water tank is empty and
H
needs to be filled
on Trays full:
I
Empty and replace them
flashing T rays missing:
I
Reinsert them
on Run the service programme
S
(see "Service programme")
flashing S ervice programme in
S
operation
flashing Turn dial to
J
on Turn dial to "O"
J

Settings and displays

Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4.
You can check the water hardness by
asking your local water supplier.
K
h
. To dispense
h
h
/
g h
Degree Water hardness
German (°dH) French (°fH)
1 1-7
2 8-15
3 16-23
4 24-30
● Switch the appliance to "eco" mode.
● Hold down the steam button
least 5 seconds. The number of LEDs 7a
, b , c , d that light up indicates
H I S J
the selected water hardness.
● Press the steam button
until the correct number of LEDs is lit; e.g.
for a hardness of 3, the LEDs 7a, b and c
( , , ) light up.
H I S
● Press the button eco once. The selected
number of LEDs should light up briefly;
this indicates that the desired setting has
been saved successfully.
If a water filter (optional extra Order No.
461732) is used, the water hardness should
be set to 1.
Note: If no button is pressed within 90
seconds, the appliance switches to "eco"
mode without saving the new settings. In
this case, the previous water hardness
setting is retained.
The appliance must be rinsed when a filter
is first used and after changing the filter.
● Fill the tank with water up to the "0,5 l"
mark.
● Place a suitable container (approx. "0,5 l")
under the nozzle 8.
● Set the dial 6 to /
g h
● When water stops coming out of the
nozzle 8, set the dial back to "O".
● Fill the water tank and the water pipes
(see "Switching on the appliance / Filling
the system").
en
1-13
14-27
28-42
43-54
for at
h
repeatedly
h
.
13