Siemens TK 52 Series Operating Instructions Manual page 16

en
This appliance can be adjusted for use
with different water hardness values (see
"Setting the water hardness").
Switching on the appliance
● Place the appliance on a flat, water­
resistant surface.
● Pull enough of the power cord out of the
storage compartment and plug it into the
electrical socket.
● Remove and rinse the water tank 11
and fill it with fresh cold water. Do not fill
above the "max" mark.
● Replace the water tank 11 and push it
firmly down into place.
● Fill the bean container with coffee beans.
● Make sure that the hot water/steam dial 6
is at "O".
● Set the power switch 1 to I.
Filling the system
When switched on for the first time, the
water pipes in the appliance must be filled.
● Place a cup under the nozzle 8.
● Turn the dial 6 to
g
the cup.
As soon as lights up, turn the dial 6
J
back to "O".
● The LED eco will now flash red. The
appliance rinses and heats up.
The appliance is ready for use when the
LED eco lights green.
This appliance also offers an "eco" mode
which uses less power.
Coffee or steam can be dispensed in the
usual way when the appliance is in "eco"
mode. When the required button is pressed,
the appliance first heats up, so it will take a
little longer until the coffee is brewed or the
machine is ready to provide steam.
To dispense hot water, first press the eco
button. The appliance heats up briefly. Now
the hot water can be dispensed as usual.
The appliance's factory settings are
i
programmed for optimal performance.
1
/ . Water runs into
h
Controls
1 Power switch
The power switch 1 on the rear of the
appliance switches the power supply on
and off.
When the power on/off switch has been
turned on, the appliance heats up, rinses
and is then ready for use.
The appliance does not rinse if it is still
warm when switched on.
Warning
Do not turn off the power switch while the
appliance is operating. Before switching off,
press the eco button to start the automatic
rinse cycle. Then switch off at the power
on/off switch.
 eco button
The appliance can be put into "eco" mode
or returned to normal mode with the eco
button.
In "eco" mode the appliance consumes less
energy.
In "eco" mode the eco button pulses green.
The temperature of the cup shelf (warming
function) is lower.
Switching to "eco" mode starts an automatic
rinse cycle.
The appliance does not rinse if:
– no coffee was dispensed before it was
switched to "eco" mode.
– steam was dispensed shortly before it
was switched off.
Note: The appliance is programmed so
that it switches to "eco" mode automatically
after about 10 minutes.
3 Coffee dispensing button
(mild coffee)
This button is used to dispense mild coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
5