ratiotec Rapidcount S Series Calibration Manual

[EN]
CALIBRATION GUIDE rapidcount S-Serie
REMARK: the calibration manual includes illustrations as examples, the values of the
sensors may differ.
Calibration Guide with calibration paper:
Press the BATCH button and keep it
1.
pressed as you turn on the device. The
device switches to the calibration mode.
The following display appears. Release the
BATCH button.
Place the white calibration paper in the
2.
banknote feeder or banknote ejector, so
that the sensors are completely covered
(Illustrations 3). Then press the BATCH
button. Calibration starts automatically.
The calibration mode may take a few sec-
onds. The following display appears.
To finish, press the RESET button and then
3.
briefly the START button. The white cali-
bration paper is ejected immediately from
the banknote ejector. The device com-
pletes the calibration process. You may
turn off the device and start again.
ratiotec GmbH & Co. KG | Tel.: +49 201 361 490 | Fax: +49 201 361 49 26 | Email: info@ratio-tec.de ratiotec GmbH & Co. KG | Tel.: +49 201 361 490 | Fax: +49 201 361 49 26 | Email: info@ratio-tec.de
1-2625
F9F9
1-2624
1E1B
white
calibration paper
white
calibration paper