Troubleshooting - Craftsman 125.21417 Operator's Manual

PROBLEM
Tool will not turn on
Bit cannot be installed
Motor overheats
Two-speed gearbox will not
properly seat into the HI or
LO position.

TROUBLESHOOTING

CAUSE
Battery is defective
Switch is dead
Brushes are worn out
Chuck is not open (Drill/Driver)
Sleeve is not released (Impact
driver)
Bit does not fit into the quick-change
chuck (Impact Driver)
Cooling vents are clogged with saw
dust or debris, or are being covered
by hand during operation.
The gears are not fully engaged.
21 ― English
SOLUTION
Replace with new, charged battery
Tool must be replaced
Tool must be replaced
Open the chuck
Release the sleeve
Use appropriately sized 1/4 in.
hexagonal quick-change bit.
Clear vents with compressed air.
Do not cover vents with hand during
operation.
Run the drill/driver for a few seconds,
then adjust the two-speed gearbox
switch again.