Operation For Battery & Charger - Craftsman 125.21417 Operator's Manual

OPERATION FOR IMPACT DRIVER
other type of bit.
NOTE:
If the driver bit is not inserted deep
enough into the sleeve, the sleeve will not
return to its original position and the driver
bit will not be secured. In this case, try re-
inserting the bit according to the instructions
above.
NOTE:
After inserting the driver bit, make
sure that it is firmly secured. If it comes out,
do not use it.
NOTE:
Insert a socket adaptor into the
sleeve to use a socket with the impact driver.
OPERATION FOR BATTERY PACK & CHARGER
BECOME FAMILIAR WITH THE
CHARGER
See Figures 23 & 24, page vi
Before attempting to use this charger,
become familiar with all of its operating
features and safety requirements.
CHARGING THE BATTERY PACK
See Figure 25, page vi
WARNING
■ If any part of the charger is missing or
damaged, do not operate it! Replace the
charger with a new one. Failure to heed
this warning could result in possible serious
injury.
■ Use an electrical testing device to check
the voltage! The voltage must comply with
the information on the rating label.
BATTERY CHARGING PROCEDURE
■ Align the battery pack to the slots on the
charger and slide it in until it locks in place.
■ Connect the charger to the power supply.
■ Allow sufficient charging time (see Product
Specifications), and then disconnect the
charger from the power supply.
■ Press the release button on the battery
pack and remove it from the charger.
NOTE:
It is normal for the battery pack
and charger to become warm (but not hot)
during charging process. If the battery does
not charge properly, check to make sure the
electrical outlet is "live".
Always charge the battery before storage!
Belt Hook (Available Separately)
See Figure 12, page iii
A belt hook is available for separate
purchase. The hook enables you to
conveniently hang the tool from your belt
when tool is not in use.
Install the hook on either side of the tool.
Insert the tab of the hook into the slot in the
tool base. Secure the hook by tightening the
screw through the hole in the hook into the
hole in the base.
To purchase the hook, see Replacement
Parts on page 22 of this manual.
WARNING
■ Do not use other battery chargers. The
battery charger supplied is specifically
designed for the lithium-ion battery used
in this tool.
■ Check the main power supply! The voltage
of the power supply must correspond with
the data on the nameplate of the battery
charger. Battery chargers operate on 120V.
■ Charge the battery pack in a location where
the temperature is between 40°F (4°C) and
100°F (38°C). If the battery pack is hot,
allow it to cool down before recharging.
NOTE:
The battery is supplied partially
charged. To ensure full capacity of the
battery, charge the battery in the battery
charger before using the product for the first
time. The lithium-ion battery can be charged
at any time without reducing its service life.
Interrupting the charging procedure does not
affect the battery.
CHARGER INDICATORS
■ Preparation: The charging process starts
as soon as the battery charger is plugged
into a power supply socket and the battery
is inserted into the charger.
■ If the battery is not inserted, a continuous
green light indicates that the charger is
plugged into a power supply socket and is
now ready to begin charging.
16 ― English