Operator Controls - WilTec 50790 Manual

Operator Controls

Slide Yoke Ring
Press down on the slide yoke ring to unlatch
the two forward legs so they can be rotated
out to the Lift's working position or in to its
storage position. A spring-loaded pin snaps
into a hole on the bottom of the slide tube, to
lock the folding legs position.
Backstop
Pivot the backstop down to prevent the base
from rolling backward, or up to allow the unit
to wheel freely.
Outriggers
The outriggers on the crossarms extend for
supporting a longer drywall panel.
To extend an outrigger, pull out the lock pin
with your right hand until you can slide the
outrigger out with your left hand. The lock
pin can engage to lock the outrigger at one
of three positions: fully retracted; extended
21 in.; or extended 33 in.
IMPORTANT: Never load a drywall panel or
operate the Lift if the lock pins are not en-
gaged at one of these three positions, or if
the outriggers are extended beyond the 33-
in. position.
To avoid damaging them, always fully re-
tract the outriggers before transporting or
storing the Lift.
Panel Support Hooks
Open the support hook on each crossarm to
support the drywall panel when it is being
loaded, or when the cradle is tilted.
To avoid damaging them, always close the
support hooks before transporting or storing
the Lift.
Slide Bar Lock
The slide bar lock holds the winch assembly
at its operating (fully extended) position.
To fold the winch assembly against the
frame (when disassembling the unit for
transport or storage), disengage the lock by
turning it counterclockwise as you lift on the
slide bar.
When you reassemble the unit for operation,
extending the winch assembly all the way
and then pressing it back slightly toward the
frame automatically engages the lock.
Never tighten the nut on the slide bar lock,
or you will be unable to fold up the unit for
transport and storage.
© by WilTec Wildanger Technik GmbH Seite 21
http://www.wiltec.info