Advertisement
Quick Links
Operation Manual
Extension Bar 140 cm for Drywall Lift
50789
Illustration similar, may vary depending on model
Please read and follow the operating instructions and safety information prior to initial operation.
Technical changes reserved!
Illustrations, functional steps and technical data may deviate insignificantly due to continuous further
developments.
Advertisement
Related Manuals for WilTec 50789
Summary of Contents for WilTec 50789
- Page 1 Operation Manual Extension Bar 140 cm for Drywall Lift 50789 Illustration similar, may vary depending on model Please read and follow the operating instructions and safety information prior to initial operation. Technical changes reserved! Illustrations, functional steps and technical data may deviate insignificantly due to continuous further...
- Page 2 The information contained in this document may alter at any time without prior notice. No part of this document may be copied or otherwise duplicated without prior written consent. All rights reserved. WilTec Wildanger Technik GmbH cannot be held liable for any possible mistakes in this operating man- ual, nor in the diagrams and illustrations shown.
- Page 3 • lift more than one panel at the same time. • exceed the maximum charge of 70 kg. © by WilTec Wildanger Technik GmbH Item 50789 Page 3 http://www.WilTec.de http://www.aoyue.eu 2021-1...
- Page 4 2. Unroll the wire cable until there is no more tension. 3. Remove the cable from its lock (Fig. 1). Figure 1 4. Remove the cable from its guide (Fig. 2). Figure 2 © by WilTec Wildanger Technik GmbH Item 50789 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 5 5. Pull out the telescopic bar upwards (Fig. 3). Figure 3 © by WilTec Wildanger Technik GmbH Item 50789 Page 5 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 6 6. Insert the extension bar (Fig. 4). Figure 4 © by WilTec Wildanger Technik GmbH Item 50789 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 7 7. Thread the wire cable of the extension bar into the guide (making sure that the cable is situated above the guide roll) (Fig. 5). Figure 5 © by WilTec Wildanger Technik GmbH Item 50789 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1...
- Page 8 To disassemble the extension bar, follow the assembly steps in reverse order. Important Note: Reproduction and any commercial use (of parts) of this operating manual, requires a written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 50789 Page 8 http://www.WilTec.de http://www.aoyue.eu...