Polaris PRO HD 4500 WINCH KIT Quick Start Manual page 4

IMPORTANT
Your POLARIS ® PRO HD 4500 WINCH KIT is exclusively designed for your vehicle. Please read the installation
instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of debris. For your
safety, and to ensure a satisfactory installation, perform all installation steps correctly in the sequence shown.
ASSEMBLY TIME
Approximately 45 minutes
INSTALLATION INSTRUCTIONS
PREPARATION
1. Shift vehicle transmission into "PARK". Turn key to
"OFF" position and remove from vehicle.
2. Lift upward and forward on the driver seat while
lifting up on the latch lever
from vehicle.
3. Disconnect black negative (-) cable from battery
FIRST, then disconnect red positive (+) cable from
battery.
WARNING
ALWAYS disconnect black negative (-) cable from
battery FIRST. Failure to do so will result in a high
current electrical arc, and may result in battery
explosion, if tool touches grounded frame. Death or
serious personal injury may occur.
A
and remove the seat
Instr 9927473 Rev 01 2016-12
D
4. Remove the hood
E
latches .
5. Remove shift lever cap
H
shift knob from shift lever
Page 4 of 13
from vehicle by rotating two
F G
, retaining screw
J
.
, and