Demtech Pro-Tester Hi-Pull Operator's Manual page 10

Rev. A, October 2020
b. The system LCD should light up, go through a self-diagnostic test and then prompt the
user to press ENTER to initiate the initialization/calibration sequence. Press ENTER
to perform the initialization/calibration procedure. For the proper operation of the Pro-
Tester do not HALT or skip the procedure.
TM
c. The system will first move the grip head in (left) to find the home position, then out
(right) to calibrate travel speed. After a short pause the grip will then move back in
(left) and stop at the A or B grip separation position depending on which is selected on
the Control Panel. This procedure verifies the Pro-Tester
condition. If the system performs as described, you are now ready to operate the system.
If the system does not perform any of the functions described above please contact
DEMTECH Services, Inc.
Pro-Tester Hi-Pull Operator's Manual
Power
ON/OFF
Switch
Fuse
Holder
Figure 5.1
is in good working
TM
Power Cord
With IEC 60320
Connector
M002
T-0100HP A M002
Page 6