Table of Contents
Advertisement
Cablite® VR LED Lighting System Installation Manual Rev 2.1
•
Electrical box and cover
•
One #10 torx for LED removal
•
Installation Manual
6.3 CabLite® VR with Dimming
The CabLite® VR with Dimming lighting system consists of the following:
•
1 to 12 downlights
•
Dimmer board (factory wired and mounted in gang box)
•
12 or 24VDC power supply (factory wired and mounted in gang box)
•
One 8' cable for connecting first downlight (factory wired and located in gang box)
•
One 4' cable for each additional downlight
•
Electrical box and cover
•
One #10 Torx for LED removal
•
Installation Manual
The CabLite® VR with dimming comes factory wired in its own gang box. All that is needed is to
connect the prewired 8' cable to the first downlight and connect the BROWN (LINE) and BLUE (NEUT)
wires to 120VAC. Refer to Figure 8 - CabLite VR with Dimming Wiring.
6.3.1 Dimmer Board
The Dimmer board (Figure 2 - Dimmer Board) allows for setting the brightness level of the LED lighting
using either the onboard potentiometer or an external (customer provided) 10k potentiometer. The
external POT can be located in the COP for easy access. The dimmer board comes factory prewired for
easy installation.
6.3.1.1
Dimmer Board Connections
•
Pin 1 is +12 or +24VDC output from supply (RED wire)
•
Pin 2 is -12 or -24VDC output from supply (BLACK wire)
•
Pin 3 is "+" LED output
•
Pin 4 is "-" LED output
•
Pins 5 & 6 are for an optional external 10K potentiometer (Customer provided) for setting
brightness level in place of using on board potentiometer. This 10K POT can be located in the
COP for easy access.
Electronic Controls, Inc.
7073 North Atlantic Ave. Cape Canaveral, FL 32920
800-633-9788
www.eciamerica.com
P a g e
| 7
Advertisement
Table of Contents
