Door Look Switch Assembly - LG WM4370H A Series Service Manual

8-2. DOOR LOCK SWITCH ASSEMBLY
Wiring
diagram
Function
LGE Internal Use Only
Circuit in the MAIN PWB / Wiring Diagram
MICOM
The door lock switch assembly consists of a heating PTC, a bimetal,
a protection PTC, and a solenoid. It locks the door during the wash cycle.
1. Operation for door closing
- After the system turns on, PTC heating starts up through terminals 2 and
4 authorizing the power on.
- After PTC heating starts up and before solenoid operation is driven,
force the system to the off position through CAM.
Door close
- Authorizing one impulse through terminal 3~4 (PTC & solenoid) will
make the door locked.
- Door lock is detected when switches in terminal 4~5 are set closed.
CAM rotation will forcibly clear off the connection.
The maximum, allowable number of impulse authorizations is 2.
Upon the third authorization of the impulse, the position of CAM goes
back to the door-open position.
- Authorizing the impulse occurs in 4.5 seconds upon input for max
performance and two authorization processes are allowed at most.
Normal operation period of PTC heating: 1.5 – 5 seconds.
(Defects from the development process.)
2. Operation for door opening
- With a temporary stop, door automatically opens by CAM rotations after
authorizing the impulse from the terminal, 3 ~ 4 and the power turns
off – maximum of 3 times of the authorizing period.
- Upon the fourth authorization of the impulse, the position of CAM goes
back to the door-close position.
MAIN PWB
Vdc
12V
1
2
3
4
NA4
Relay
Relay
35
YL
1 2
BL
2 3
RD
3 4
BK
4
5
AC
Common
terminal
of valve
Door switch
Copyright © 2016 ~ 2017 LG Electronics Inc. All rights
reserved. Only training and service purposes.
Vac