LG WM4370H A Series Service Manual page 17

No. P o r
10 Intermittent
spin
11 Rinse
spin
12 Remaining
spin
13 Rinse water
supply
14 Rinse
15 Last
drainage
16 Disentangling
Intermittent spin • The same as item 10.
17
18 Main spin1
Main spin2
19
Remaining spin • The same with item 12.
20
Disentangling
21
End
22
LGE Internal Use Only
c e s s
• To reach the correct set speed, the motor rotates clockwise and
counterclockwise directions after spin process starts.
• If the water level frequency is lower than 23.0 kHz,
a washer senses suds and starts suds removal process.
• In this process, the remaining water during washing process is
extracted and the selected speed is kept.
• Removing suds process is in active mode at this cycle.
• After spin finishes, the drum rotates by remaining spin power until it
stops. Motor power is off.
• This process is overlapped with next process.
• Water supply for rinse process.
• Rinsing process.
• After spin finishes and power is not supplied to motor, the drum
rotates by remaining spin power.
• If rinse hold is selected, the drainage is not proceeded after rinse
finishes.
• The same as item 9.
• The same as item 11.
• At the end of a main spin, the spin speed will reach the selected rpm.
• After spin finishes, disentangling starts to remove unbalanced
laundry.
• After 'end' signal is displayed, it stays for 8 seconds and power is
automatically turned off. (Auto type door switch)
• After door switch is off, end signal is displayed in the case of
manual type and it takes around 2 minute to turn off door switch.
E x p a l n t a o i n
Copyright © 2016 ~ 2017 LG Electronics Inc. All rights
17
reserved. Only training and service purposes.