Ped Declaration - Lennox WA Series Installation, Operating And Maintenance

PED DECLARATION

All Units are compliant with the PED directive 97-23-CE.
IMPORTANT NOTICE
All work on the unit must be carried out by a qualified and authorised employee.
Non-compliance with the following instructions may result in injury or serious accidents.
Work on the unit :
. The unit shall be isolated from the electrical supply by disconnection and locking using the main isolating
switch.
. Workers shall wear the appropriate personal protective equipment (helmet, gloves, glasses, etc.).
Work on the electrical system :
. Work on electric components shall be performed with the power off (see below) by employees having valid
electrical qualification and authorisation.
Work on the refrigerating circuit(s) :
. Monitoring of the pressures, draining and filling of the system under pressure shall be carried out using
connections provided for this purpose and suitable equipment.
. To prevent the risk of explosion due to spraying of coolant and oil, the relevant circuit shall be drained and at
zero pressure before any disassembly or unbrazing of the refrigerating parts takes place.
. There is a residual risk of pressure build-up by degassing the oil or by heating the exchangers after the
circuit has been drained. Zero pressure shall be maintained by venting the drain connection to the atmosphere
on the low pressure side.
. The brazing shall be carried out by a qualified brazer. The brazing shall comply with the standard NF
EN1044 (minimum 30% silver).
Replacing components :
. In order to maintain CE marking compliance, replacement of components shall be carried out using spare
parts, or using parts approved by Lennox.
. Only the coolant shown on the manufacturer's nameplate shall be used, to the exclusion of all other products
(mix of coolants, hydrocarbons, etc.).
CAUTION :
In the event of fire, refrigerating circuits can cause an explosion and spray coolant gas and oil.
Installation - Operation - Maintenance manual (IOM) • AIR COOLED CHILLERS & SPLIT UNITS - 1106-E
The following note must be followed carefully
• 4 •