Advertisement
Preparing To Run Dirac Live
Along with your Emotiva processor you will receive the following:
•
A precision calibrated microphone.
•
A USB digitizer cable - for connecting the microphone to your computer.
•
The Emotiva Dirac Network Interface - which connects to your network to facilitate the
network connection between the Dirac Live software and your processor.
•
A small 5-port Ethernet switch and some Ethernet cables.
•
(Depending on how your network is configured you may need to purchase one or more
additional low cost Ethernet cables of various lengths.)
•
AC adapters for the Network Interface and the Ethernet switch.
Soon after receiving your unit you will receive an e-mail that includes instructions about where to
activate your Dirac Live user account and download the latest version of the Dirac Live software.
Here are the steps required to use Dirac Live:
•
UPDATE THE FIRMWARE ON YOUR PROCESSOR TO THE CURRENT VERSION.
•
Create your Dirac User Account.
•
Download the microphone calibration file onto your computer and place it where you
will be able to find it.
•
Download the software and install it on your computer.
•
Connect your processor, the Network Interface box, and your computer, to your network.
•
Connect the microphone to your computer via the provided USB digitizer cable.
•
Run the software.
•
Follow the onscreen directions in the software, take your measurements, and download the
filter or filters you create to you processor.
•
(At this point, if you prefer, you may disconnect your processor, the Network Interface box,
and your computer, from your network.)
•
Set up the configuration options in your processor to instruct it which Dirac Live filters to use
with which Inputs.
Installing The Dirac Live Software
Page 7
Advertisement
