Setting Up Command Line Interface Management - 3Com 4500 Getting Started Manual

44 C 3: M
HAPTER ANAGING
Setting Up Command
Line Interface
Management
User Interface Overview
Y S
OUR WITCH
b In the Open field, type the unit's IP address:
Telnet xxx.xxx.xxx.xxx
(where
xxx.xxx.xxx.xxx
c Click OK.
2 Press Enter to open a login prompt.
If the login prompt does not begin immediately, press Return a few times until it
starts.
3 At the login prompt, enter admin as your user name and press Return at the
password prompt. If you have logged on correctly, <4500> is displayed as shown
below.
****************************************************************************
* Copyright(c) 2004-2007 3Com Corp. and its licensors. All rights reserved.*
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
****************************************************************************
Login authentication
Username:admin
Password:
<4500>
%Apr 4 06:13:31:519 2000 4500 SHELL/5/LOGIN:- 1 - admin(10.10.11.222) in
unit1 login
<4500>
4 Enter the system-view command and Enter.
5 Enter interface vlan 1 and Enter.
6 Enter the IP address and subnet mask for the switch as follows:
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
(where
xxx.xxx.xxx.xxx
mask of the switch)
7 Enter the default gateway for the switch:
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the default gateway)
8 Enter the save command to save the configuration (the configuration is not
saved automatically when the switch is powered down).
The initial set up of your switch is now complete and you can set up your
management method. See "Methods of Managing a Switch" on page 34.
This section describes how you can set up command line interface management
using a local console port connection or over the network.
User interface configuration is provided by the switch to configure and manage
the port data. There are two types of user interfaces:
is the switch's IP address)
is the IP address and
mmm.mmm.mmm.mmm
*
*
is the subnet