Baumann Beluga Use And Maintenance Instructions page 8

USE AND INSTALLING INSTRUCTIONS
GENERAL INSTRUCTIONS
Carefully read the following important information
regarding installation safety and maintenance.
Keep this information booklet accessible for further
consultations.
USE INSTRUCTIONS
CONTROL PANEL (Fig.L)
- Light ON/OFF
- Reduce fan speed (4 to 1)
- ON/OFF. Switch on the cooker hood at speed 1.
Switch off the cooker hood at any speed.
- Increase fan speed (1 to 4)
- TIMER - Activate the timer function.
The timer will automatically switch off the fan
after 15 minutes. When the fan speed is set
to 4 the timer activates automatically. After 15
minutes of activity the fan will automatically
switch to speed 3.
REMOTE CONTROL (Fig.I)
SAFETY WARNINGS
• The hood has been designed to remove the
kitchen smells; any other additional use shall be
regarded as non-intended.
• Aerate the room if other appliances that are not
supplied by electrical power are being used while
the hood is on.
• Do not leave the cooker on if it is not being used.
• Do not flambé food directly under the cooker
hood to prevent the grease filter catching fire due
to flames.
• Constantly check food frying to avoid that the
overheated oil may become a fire hazard.
• Do not check the status of the filters while the
cooker hood is operating.
• Do not touch the light bulbs after appliance use.
USE AND MAINTENANCE
It is recommended to switch on the appliance
before cooking. It is also recommended to leave
the appliance in operation for 10 minutes after
cooking is terminated in order to completely
eliminate cooking vapours and odours.
The proper function of the cooker hood is
conditioned by the regularity of the maintenance
operations, in particular, the active carbon filter.
Clean the fan and other surfaces of the cooker
hood regularly using a cloth moistened with
denatured alcohol or non abrasive liquid detergent.
8
WARNING: unplug the appliance or switch off the circuit
EN
breaker before carrying out maintenance operations.
METAL ANTI-GREASE FILTERS
The metal anti-grease filters capture the grease
particles of the vapours that develop during
cooking, therefore they are subject to clogging
according to the frequency of the use of the
appliance.
In order to prevent fire hazard, it is recommenda-
ble to clean the filter every 2 months by carrying
out the following instructions:
• Remove the filters from the cooker hood and
wash them in a solution of water and neutral
liquid detergent, leaving to soak.
• Rinse thoroughly with warm water and leave to
dry.
The filters may also be washed in a dishwasher.
The aluminium panels may alter in colour after
several washes. This is not cause for customer
complaint nor replacement of panels.
INSTALLING INSTRUCTIONS
This hood has been arranged to be installed above
a cooktop. It can be used in 2 ways:
• (Fig. A): the air is purified through the metal grease
filters and discharged to the outside through a tube
through the appropriate conduct outside of the
house. This installation provides that the space
between the false ceiling and the ceiling is at least
660 mm, with the engine installed to the structure
in a vertical position (Fig. A1).
• (Fig. B): the air is purified through the metal grease
filters and discharged to the outside through a tube
through the appropriate conduct outside of the
house. This installation provides that the space
between the false ceiling and the ceiling is at least
330 mm, in this case, the engine must be applied
to the structure in a horizontal position (Fig. B1).
WE SUGGEST TO HAVE INSTALLATION CARRIED OUT BY
QUALIFIED PERSONNEL, IN COMPLIANCE WITH ALL THE
CURRENT REGULATIONS AND IN PARTICULAR WITH THE
ONES CONCERNING AIR EXHAUST AND ELECTRICAL
CONNECTION.THE MANUFACTURER CANNOT BE HELD
LIABLE FOR DAMAGES CAUSED BY IMPROPER INSTALLATION
OR IF IT HAS NOT BEEN CARRIED OUT ACCORDING TO THE
STATE-OF-THE-ART.
IMPORTANT
• The appliance must be installed at a minimum
height of 650 mm from an electric cooker stove,
or 750 mm from gas or combined cooker stoves.
• If a connection tube composed of two parts is
used, the upper part must be placed outside the
lower part.
• Do not connect the cooker hood exhaust to
the same conductor used to circulate hot air