Connecting Cables To Terminals - Kenwood KRC-479R Instruction Manual

Connecting Cables to Terminals

ISO connector unsupported car
2CAUTION
When only two speakers are being connected to
the system, connect the connectors either to
both the front output terminals or to both the rear
output terminals (do not mix front and rear). For
example, if you connect the + connector of the
left speaker to a front output terminal, do not
connect the - connector to a rear output
terminal.
2WARNING
If you connect the ignition cable (red) and the
battery cable (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may
start a fire. Always connect those cables to the
power source running through the fuse box.
If no connections are made, do not let the cable come
out from the tab.
Connect either to the power control terminal
when using the optional power amplifier, or
to the antenna control terminal in the vehicle.
Ignition key
switch
Car fuse box
(Main fuse)
–
+
Battery
Front left output (White)
(KRC-479R only)
Rear left output
(White)
Rear right output
(Red)
Front right output (Red)
(KRC-479R only)
Power control/ Motor antenna
control cable (Blue/White)
P.CONT
ANT.
CONT.
ACC
Car fuse box
Ground cable (Black) - (To car chassis)
NOTE
To connect the Disc
KENWOOD disc
changer, consult your Disc
changer input
changer manual.
Power Control
terminal (P.28)
FM/AM
antenna input
TEL mute terminal
Wiring harness
(Accessory1)
FRONT • L
FRONT • R
Ignition cable (Red)
Battery cable (Yellow)
— 27 —
Antenna Cord (ISO)
Fuse (10A)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
Plug (P.29)
White/Black
To front left
speaker
+
White
Gray/Black
To front right
speaker
+
Gray
Green/Black
To rear left
speaker
+
REAR • L
Green
Purple/Black
To rear right
speaker
REAR • R +
Purple