English - Braun ExactPower EP 80 User Manual

English

Our products are designed to meet the highest standards of quality,
functionality and design. We hope you enjoy your new Braun appliance.
Important
• Do not use the trimmer near or over basins filled with water
(e.g. bath tubs, showers etc.).
• Do not wind the cord around the appliance.
• For safety reasons, periodically check the cord for damage and replace it
if necessary.
Description
1 Distance comb
2 Pivoting twin cutter system
a beard trimmer
b contour trimmer
c release buttons
3 Speed selector
Technical specifications
Power supply: 100 – 240 V
Wattage: 5
Charging your beard trimmer for cordless operation
• For the first 3 chargings: Connect the trimmer to the mains with the on/
off switch on position «0» and charge it for at least 10 hours. The pilot
light indicates that the trimmer is connected to the mains.
• Once the trimmer is completely charged, use it without the cord until
discharged.
• Then recharge to full capacity again (subsequent charges will take about
8 hours).
• A full charge will give up to 30 minutes of cordless trimming depending
on your beard. However, the maximum capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for charging is 15 °C to 35 °C.
4 On/off switch
with beard length selector
5 Memory switch
(for 6 beard length settings)
6 Pilot light
/ 50 or 60 Hz (automatic adaptation)
2
7