16
Spring resistance settings
Risk of injury due to tipping over!
Caution
Set spring resistance to fit the user's activity, size, and weight:
Set release lever N to 0 (previous page)
Use lever T on balance unit to set spring resistance.
Down = low spring resistance
o
Up = high spring resistance
o
Make sure that release lever latches
Assure that spring resistance is set to the same level on
both sides
Lifting the user into training position
Danger of injury due to not using a chair/wheelchair!
When lifting up or sitting the user down:
Caution
Note: When using the OmniStand™ it may be necessary to lift or lower the exerciser with the help of an assistant
who is trained for the procedure.
To lift the user:
Set height of the knee support and upper pipe frame
Before starting the training session, make sure that transport castors with brake/wheel locks are applied.
Move exerciser directly behind OmniStand™ in a wheelchair
Secure wheelchair to prevent it from moving
Put the user's feet on the tread of OmniStand™
Put knees on simple knee support
Lift the user and stand him/her into the training position
Apply pelvic safety strap and secure the user with belt buckles
To lower the user:
Move wheelchair directly behind the OmniStand™
Remove pelvic safety strap from user
Seat user in chair or wheelchair
Remove the user's feet from the tread of the OmniStand™
COPYRIGHT © 2016, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED.
Set spring resistance to fit the user's activity, body size and body weight.
Always position chair/wheelchair directly behind exerciser
Lock brakes of wheelchair
OMNISTAND™ USER MANUAL
T
Need help?
Do you have a question about the OMNISTAND and is the answer not in the manual?