Removing The Simple Knee Support - ACP OMNISTAND User Manual

OMNISTAND™ USER MANUAL
Adjusting the broad stay tubes
 Pull out and hold the safety catch C
 Adjust stay tubes to fit the width of the patient's pelvis
 Release safety catch C to lock in place
 Make sure that safety catch audibly clicks into place
 Make sure that settings left and right are the same
Adjusting the knee support
Risk of injury due to incorrectly adapted simple knee support!



Caution
Note: The simple knee support provides support for the user when rising and standing or during balance exercise.
Adjusting the simple knee support does not require any tools.
In order to be able to lower the user quickly, put a chair or wheelchair directly behind the OmniStand™ during the
training session.
Setting the height:
 Loosen star-shaped handle F on first vertical pipe
 Set height using marks
 Tighten star-shaped handle F on first vertical pipe
 Repeat process to set height on second vertical pipe
 Make sure that height settings of left and right vertical pipes are the same

Removing the simple knee support:

 Remove simple knee support D before the user is standing
 Pull ball catch pin E out of securing system
 Pull knee support D out of securing system
 Make sure that user is able to maintain upright standing
position safely and without assistance
COPYRIGHT © 2016, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED.
If removing the knee support, ensure the exerciser has sufficient lower extremity
strength and control to stand independently and has sufficient endurance to do so.
Prior to every training session, adapt knee support to the user's individual needs.
Adjust knee support so as to prevent overextension of joints and damage to muscles,
tendons or ligaments.
C
D
E
13
C
F