ROLS
Remote Optical Laser Sensor
SAFEGUARDS AND PRECAUTIONS:
Laser hazards
Eye injury from beam - Do not look into the direct or reflected beam; can cause eye injury up to 25 ft (7.5 m) away.
Visual interference (glare) with pilots and drivers - Interferes with vision up to 525 ft (160 m) away. Can be a
distraction up to 1 mile (1.6 km) away. NEVER point any laser towards aircraft or vehicles; it is unsafe and illegal.
Safe use guidance
Class 2 lasers are considered safe for accidental eye exposure. Do not look or stare into beam. Do not aim at aircraft.
This is not a toy. Always supervise children.
Read and follow all instructions in this instruction sheet carefully and retain this sheet for future
reference.
Do not use this instrument in any manner inconsistent with these operating instructions or under any
conditions that exceed the environmental specifications stated.
This instrument is not user serviceable. For technical assistance, contact the sales organization from which you
purchased the product.
DESCRIPTION:
The Remote Optical Laser Sensor has a visible red laser light source and green LED
on-target indicator. The class 2 laser source acts as the aiming device during setup
and can accurately measure speeds from 1-250,000 RPM from a distance of up to 25
feet with a maximum offset angle of 60 degrees from the rotating object. The sensor is
housed in a threaded 303 stainless steel tube and supplied with a 90-degree mounting
bracket, jam nuts and an eight foot shielded cable. ROLS-P comes with a 3.5mm (1/8")
male stereo plug adapter. ROLS-W comes with 4 tinned wires.
SPECIFICATIONS:
Speed Range:
1-250,000 RPM
Illumination:
Visible Red Laser, Class 2
Laser Specifications: Classification: Class 2 (per IEC 60825-1:2014)
This product complies with IEC60825-1 Ed. 3 and 21 CFR 1040.10 and 1040.11 except for
deviations pursuant to Laser Notice No. 50 of June 2007.
Maximum Laser Output: 1mW
Pulse Duration:
Laser Wavelength:
Beam Divergence:
Beam Diameter:
Laser Diode Life:
On-Target Indicator: Green LED on wire end cap
Operating Range:
up to 25 feet [7.6 m] and 60 degrees offset from target
Power Requirement: 3.3 – 15 Vdc, 0.4W max
Output:
Open Collector with internal pull up resistor to supply voltage
Positive pulse when target present – Output Voltage=Supply Voltage
Optional – TTL pulse, Negative pulse (Contact factory)
Diode Laser
Max. output power: < 1 milliwatt
Wavelength: 650 nanometers (visible light)
Min. divergence: 0.5 milliradian
Output: Continuous (CW)
Laser hazard classification: Class 2
Continuous
650 nm
<1.5 mrad
4 x 7 mm typical at 2 meters
8,000 operating hours MTBF (1 year warranty)
Manufacturer:
Monarch Instrument
15 Columbia Drive
Amherst, NH 03031 USA
Country of Origin: USA
Contact info: www.monarchinstrument.com
Need help?
Do you have a question about the ROLS and is the answer not in the manual?
Questions and answers