Kenwood KDC-DAB4551U Instruction Manual page 38

Symptom
Correct characters are not displayed (e.g.
album name).
Bluetooth
Symptom
The hands-free talk volume is low.
No beep is heard at reception of an incoming
call.
Voice is not recognized.
"NO NUMBER" appears.
"NO DATA" appears.
"NO ENTRY" appears.
"HF DISCONCT" appears.
"HF ERROR 07" appears.
"HF ERROR 68" appears.
"UNKNOWN" appears.
"DEVICE FULL" appears.
"PIN CODE NG" appears.
"CONNECT NG" appears.
"PAIRING NG" appears.
"NO MARCHING" appears.
"TOO SOFT" appears.
"TOO LOUD" appears.
"TOO LONG" appears.
"NO PHONEBOOK" appears.
"NO MESSAGE" appears.
"NO RECORD" appears.
"MEMORY FULL" appears.
"NO VOICE" appears.
38
English
This unit can only display letters (upper case), numbers, and a limited number of
symbols.
The hands-free talk volume can be adjusted independently. Adjust it during hands-
free talk. [MIC GAIN], [NR LEVEL] and [EC LEVEL] of <Bluetooth Setup> (page 24).
No beep is heard depending on the type of your cell-phone. The [CALL BEEP] of
<Bluetooth Setup> (page 24) is set ON.
■
The vehicle window is open. If the surrounding noise is large, voice cannot be
recognized properly. Close the vehicle windows to reduce noise.
■
Small voice. If voice is too small, it cannot be recognized properly. Speak into the
microphone a little more loudly and naturally.
■
The person uttering the voice tag is not the one who registered the it. Only the
voice of the person who registered the voice tag can be recognized.
The calling party does not notify a caller ID. / There is no phone number data.
There is no outgoing call list. / There is no incoming call list. / There is no missed call
list. / There is no phone book list.
The cell-phone has not been registered (pairing).
The unit cannot communicate with the cell-phone.
The memory cannot be accessed. Turn off the power and on again. If this message still
appears, press the reset button on the control unit.
The unit cannot communicate with the cell-phone. Turn off the power and on again. If
this message still appears, press the reset button on the control unit.
The Bluetooth device cannot be detected.
5 Bluetooth device have already been registered. No more Bluetooth device cannot
be registered.
The PIN code is wrong.
The unit cannot be connected to the device.
Pairing error.
The voice tag is wrong. Voice cannot be recognized because of an unregistered voice
tag, etc.
Voice is too small and cannot be recognized.
Voice is too large to be recognized.
The word or utterance is too long to be recognized.
Data is not contained in the phone book.
No short message in In Box.
The voice tag is not registered in the phone book.
The number of voice tags reaches the maximum number to be registered in the phone
book.
No call.
Remedy/Cause
Remedy/Cause