Page 1
- 1 1 M L E ME N T E T E R O N O B A N D E R L A T S I D E R...
Page 2
WHEN ORDERING PARTS, ALWAYS GIVE PART NUMBER AND DESCRIPTION. Please note: In an effort to keep the price on Maco Antennas down, we have decided not to clean up all the burrs and rough edges on the parts. We recommend that you deburr and clean up each part with files, sandpaper, etc. so that they go together easily. We are aware this needs to be done but have elected not to do it to save you the money we would have to add to the price of the kit for this service.
6 inches into the ends of the center sections (TllP). Snug the clamps but don’t tighten at this time because the arms will have to be adjusted after installing the reflector wire. FLATSIDER 6...
Page 5
FIGURE 3B ELEMENT MOUNTING Mark each element at the center and be sure that the boom-to-element mounts (BE2P) are centered on the elements before tightening hardware. Starting 1” from the director end of the boom, mount each element using 2” U- bolts, saddles, boom-to-element mounts and hardware as shown.
Page 6
( C U S T O M E R F U R N I S H E D ) ; I N S U L A T O R D E T A I L 2 D D E T A I L 2E D E T A I L 2C FLATSIDER 6...
Page 7
F L T W S H R R E F L E C T O R A S S E M B L Y ( F I G U R E 3C) 4 E Q ELEMENT ASSEMBLY & MOUNTING FLATSIDER 6...
Page 8
‘ C U S T O M E R FURNISHEiI COAXIAL CABLE W A S H E R G A M M A S T R A P S (SLIDER) HORIZONTAL CAPACITOR ADJUSTMENT: 1” VERTICAL CAPACITOR ADJUSTMENT: 1 112” GO1 P HORIZONTAL/VERTICAL GAMMA MATCH GAMMA MATCH MOUNTING FLATSIDER 6...
Page 9
I n s t a l l i n g a n d r i g g i n g t o w e r s , m a s t s a n d a n t e n n a s r e q u i r e s p e c i a l i z e d s k i l l s a n d e x p e r i e n c e . I n f o r m a t i o n s u p p l i e d b y M a s s u m e s t h a t a l l p r o d u c t s w i l l b e i n s t a l l e d b y p e r s o n n e l h a v i n g t h e s e s k i l l s a n d h a v e i n s t a l l e d s i m i l a r p r o d u c t s b e f o r e .
Need help?
Do you have a question about the Flatsider 6 and is the answer not in the manual?
Questions and answers