Kenwood XD-855 Instruction Manual page 10

•
2 "AA" size batteries (UM/SUM-3, R6,
HP-7 or similar)
10 EN
Demo mode
To enter into the demonstration mode:
When the unit is in the standby mode, press the
EX.BASS/DEMO button again.
To cancel the demonstration mode :
Press the EX.BASS/DEMO button.
• The demonstration mode will be cancelled and
the unit will be in the low power consumption
mode.
Notes :
• When the unit is in the low power consumption
mode, the display will disappear.
• When the power is on, the EX.BASS/DEMO but-
ton can be used to select the extra bass mode.
• When the power supply is restored after a power
failure or the power cord is unplugged and
plugged in again during use, this unit will enter
into the demonstration mode.
Remote control
• When inserting or removing the batteries, push
them towards the
• Installing the batteries incorrectly may cause the
unit to malfunction.
Precautions for battery use :
• Replace all old batteries with new ones at the
same time. Do not mix old and new batteries.
• Remove the batteries if the unit will not be used
for long periods of time. This will prevent poten-
tial damage due to battery leakage.
• Do not use rechargeable batteries (nickel-
cadmuim battery, etc.)
Note concerning use :
• Replace the batteries if the operating distance
is reduced or if the operation becomes erratic.
• Periodically clean the transmitter LED on the re-
mote control and the sensor on the main unit
with a soft cloth.
• Exposing the sensor on the main unit to strong
light may interfere with operation. Change the
lighting or the direction of the unit.
• Keep the remote control away from moisture,
excessive heat, shock, and vibrations.
battery terminals.