Parallel Outputs - Bosch WT PSI 6 Series Technical Information

7.3.2

Parallel outputs

<Control ready>
1070 080 086-101 (01.01) GB
PSI 6XXX.190 W1
The <Control ready> signal indicates the ready status of the weld timer. In parallel, the
green LED ⇑ on the font panel is lighted. This signal is canceled in the event of a fault, e.g.
with:
- E-STOP circuit open
- a fault in the [Sequence] or an inadmissible deviation of a monitored value which
has been defined as a fault in the Fault Allocation in the Basic-Setup menu
- a battery fault that has been defined as a fault in the Fault Allocation in the Basic-
Setup menu, etc.
Page 11-3: Messages concerning the timer status,
page 11-4: Messages concerning current monitoring
NOTE
The programming terminal signals the cause of the fault in the Timer-Status-Message
window. Detailed information is displayed by calling up diagnostics for I/Os or timer diag-
nostics.
When the cause of the fault has been cleared, the ready state is restored by:
- the <Reset Fault with WC> signal, please refer to page 7-22
- an operation in the BOS-5000 software, e.g. in the Diagnostics -Timer window or
- the green button on the front panel of the PSI 6XXX.190 W1.
Electrical connection
7-23