Huawei OceanStor 2600 V3 Product Description page 105

OceanStor 2600 V3
Product Description
15
17
Table 4-34
Table 4-34 Indicators on the rear panel
Num
ber
14
15
6
2
Issue 09 (2019-05-15)
Connectivity status indicator
Half-height PCIe slot
NOTE
The default IP address of the management network port (Mgmt) on the quorum server is
192.168.128.200, and the default subnet mask is 255.255.255.0.
describes the indicators on the quorum server rear panel.
Indicator
Data transmission status
indicator
Connectivity status
indicator
UID indicator
Power module indicator
Copyright © Huawei Technologies Co., Ltd.
16 Full-height PCIe slot
NOTE
This slot is reserved and does not install PCIe
here.
- -
Color State
Yellow l Off: No data is being transmitted.
l Blinking: Data is being transmitted.
Green l Steady green: The network is
properly connected.
l Off: The network is not connected.
Blue The UID button/indicator helps identify
and locate a quorum server in a rack.
You can turn on or off the UID indicator
by manually pressing the UID button or
remotely running a command on the
CLI.
l Steady on: The quorum server is
located.
l Off: The quorum server is not
located.
l You can hold down the UID button
for 4 to 6 seconds to reset the
system.
Green l Steady green: The power input is
normal.
l Off: There is no AC power input, or
the power module is in the standby
state or is faulty.
4 Hardware Architecture
97